High-Capacity Line Strobe Controller Optimized for Computational Imaging and Multi-Light Switching

Enables high-speed ON/OFF control of high-power lighting, which was not possible with conventional models such as IWDV-300S-24.

Supporting switching speeds of approximately 100 kHz, it allows multiple illuminations to be switched and illuminated within a single workpiece transfer.

Multi-light control with a single camera

The controller allows different illuminations to be turned on for each line scan, significantly reducing the number of cameras required and saving installation space on inspection stages.

Scalable architecture

Up to 8 driver units can be connected to a single cotrol unit, providing flexible system expansion.

Simplified lighting control through programming mode

Each trigger input can activate a preset output pattern configured via LAN communication.

The system supports up to 32 trigger programs, enabling dynamic lighting control for complex inspection processes.

Encoder signal input

Accepts differential A-phase and B-phase signals for precise synchronization with moving stages.

Versatile signal I/O interfaces

Equipped with RS-422 IN/OUT, TTL IN/OUT, LVTTL IN/OUT, and Open-Collector IN/OUT compatibility for seamless system integration.

Camera trigger output

Provides frame and line trigger outputs, allowing the IHP Controller to act as the master device controlling the image capture timing.